|
Four steps
to rigging the plastic worm
First step is to pass the line through the
slip sinker and tie the line to the hoook. Push the piint of
the hook into the center of the worm about one-half of an inch.
Second step is to bring the point of the hook
out of the worm one-half inch back from the head.
Third step is to pull the hook back through
the worm until the eye of the hook disappears into the head of
the worm one-fouth of an inch. Rotate the worm on the hook until
the point of the hook is pointed up.
Fourth step is to touch the point of the hook
to the worm - hold the worm firmly and push forward on the hook
until the point is inserted into the worm past the barb. When
properly rigged, you should have a straight worm as shown.
This information is
courtesy of M-F Manufacturing Co., manufacturers of molds, plastic
and all the supplies you need to make your own soft plastic lures.
See how to make
soft plastic lures.
Fishing
Tips
Merchandise | Specials | Fishing Reports | Fishing News
|
